A way of finishing BHO cannabis concentrate is called Shatter. This is a cannabis extraction with solvents, since gas is needed to dissolve resin and drag it out.
The definition of the term adapted to cannabis would be something like BHO that breaks, that is, rigid, crystallized and hard. This is one of the first types of BHO finishes, since until then most users consumed it as a viscous and unhardened oil.
The best way to make Buy Shatter In Burnaby is with a closed circuit machine and a vacuum oven connected to a pump, for safety, speed and for its ability to restore the gas.
We put the weed in the corresponding chamber, close it, turn on the gas, wait a little bit and then recover the gas. We take out BHO and put it in the vacuum oven on a pyrex tray or similar, turn up the temperature to 98.6º F. (37º C.) and switch on the pump. This way we get the Shatter texture without doing anything else, in some cases it takes a day and in others it may take up to a week.
How to make BHO Shatter with vacuum
But not everyone can afford to invest thousands of dollars in equipment for cannabis extraction, so we’re going to explain how to make Shatter in different ways. The technique to get the texture of BHO shatter has more to do with the purging than the way of extraction. In this post you can learn how to make BHO in an easy way, once extracted the ideal is to eliminate the gas with a temperature that does not reach 113º F. (45º C.) and a vacuum pump of at least 1 bar of pressure, but the more powerful the better. At the beginning the extraction is swollen with the vacuum pressure, but as time goes by it will make less and less bubbles, until at some point, where there was air and bubbles, holes are formed, and the concentrate acquires a hard texture that is no longer sticky.
How to make BHO Shatter without vacuum
With the help of a hot plate, time and patience you can also achieve the Shatter finish. BHO is extracted on a pyrex plate to which we have to put baking paper or a silicone tablecloth, trying to make a homogeneous layer. Then it is placed on a heating plate at a temperature between 104 and 111º F. (40-44º C.) and we start purging.
Large gas bubbles will come out at first, which if we pop them we help it get out sooner. Then the bubbles will be smaller and smaller and we will notice that when we blow them they are harder and less sticky. Until a moment comes when they are very small and when they explode they break up into small rigid lumps, at which point the extraction is almost clean.
We leave it at a constant temperature for a few more hours and it may be considered done. You will see that a thin BHO layer remains with a hard and not very sticky texture unless we apply heat to it.
Leave a Reply